Share
Complete your modular speed bump setup with this recycled rubber end cap. Designed to match our 2-inch high, 6-foot rubber speed bump, this accessory adds a clean, finished edge to either side of the installation. It improves both appearance and function by creating a sloped transition that reduces tripping hazards and helps drivers navigate the bump with more control.
Made from the same high-traction rubber as the speed bump, this end cap resists weather, moisture, oils, and UV rays.
|
Works on either end of the modular speed bump for a clean finish. |
|
Two molded pegs insert directly into the bump’s drainage channels. |
|
Use on asphalt or concrete with installation hardware and adhesive. |
This end cap is designed to match the 2-inch high recycled rubber speed bump. Together, they create a complete traffic control solution for parking lots, access lanes, and low-speed roadways. Each cap adds a sloped, finished edge to your installation and helps prevent tripping hazards or vehicle jolts at the ends. Get your Speed Bump from SONCO here, along with the matching installation hardware!
Parking Lot Safety Tips |
|
Learn practical tips to improve parking lot safety, from better signage to traffic control equipment and quality floor markings. |
The Complete Guide to Traffic Control Devices |
|
Master the essentials of traffic control and keep roads safe with this comprehensive guide to devices, strategies, and best practices. |
| Weight | 5.000000 |
|---|---|
| Length | 7" |
| Width | 12” |
| Material | Rubber |
| Height | 2.02” |
